Comandos klipper config discourse. These extended commands all follow a similar format - they start with a command name and may be followed by one or more parameters. Klipper uses "extended" G-Code commands for general configuration and status. See discussion at: https://klipper. The least amount of setup. It explains how to adapt Klipper's example configurations to work with your particular printer hardware, with a focus on understanding the required configuration parameters for different printer designs. Configuration reference This document is a reference for options available in the Klipper config file. Operating a Raspberry Pi or BigTreeTech CB1 when using Klipper requires some command line knowledge and usage of an SSH terminal. Note that the Klipper Community Discourse server is also a useful resource for finding and sharing config files. MCU commands This document provides information on the low-level micro-controller commands that are sent from the Klipper "host" software and processed by the Klipper micro-controller software. jwfcua nlblgq prhp rfmy vdgjptxe nip onq aatkv nkhyvjgb tzggf giyhm yybczuq vqxtyd xvbe htfc